The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.

Coreflash D300 Flash Tube (2nd and 3rd generation only)

(No reviews yet) Write a Review
Calculated at Checkout

Coreflash D300 3 pin Flash Tube.

User Changable 
3 pin

These tubes are compatible with:

Coreflash CF-D300 2nd Generation (2009 release)

New Coreflash CF-D300 3rd Generation (2012 release)

(please see images)


Please note- If you are regularly shooting at low power levels it is recommended that at the end of each shoot you turn the power up to full and flash the unit several times. This process helps to keep the gas performing at its optimum level and burns off the black powder that may start to accumulate on the glass. But in particular will help preserve the life of the flash tube. - When moving the unit into new lighting position while the unit is still warm do so as gently as possible and ideally allow to cool before packing away. - If a flash tube does not fire at very low power levels then it is likely the flash tube is getting worn and needs replacement - When replacing a tube ensure the unit is unplugged and cooled down before touching
Take care to ensure the flash tube legs are fully pushed in when replacing by applying gentle pressure. If the unit has had a minor knock it is possible these legs may be dislodged and they should be re pushed in again, but if it was a major knock the unit should be checked by an authorised repairer.
It is advised that the new tube is handle with protective gloves or a soft cloth.